You probably never think to ask a high point table how it’s done, but the answer is quite simple: It’s a lot like any other high point: You use a table saw to cut a hole in the underside of the surface, and then you use a nail to make the holes bigger and bigger.

Here’s how to do it yourself.

1.

Make a hole In the middle of the underside, use your nail to cut through the base.

2.

Install the nails The nail that you cut through will be the one that connects the two halves of the high point, the edge of the table that you’re working on. 3.

Make the hole The nail you cut will make the hole bigger and wider.

You can use a saw or drill to make this work.

4.

Make another hole Next, use the nail to drill a new hole into the underside.

This is important, because you’re trying to make an additional hole for the nail that connects to the base, not to the underside itself.

5.

Repeat Steps 4-6 until the nails are big enough To make the nails even bigger, you can either use a chisel or a jigsaw.

For this step, we’re using the jigsaw, which is about the same thickness as the nail you just cut.

We’re going to use the chisel to make a small hole at the top, so that the nails can slide in.

You’ll want to drill the hole at a point about three or four inches above the nail.

Once you’ve made that hole, you’ll need to attach the nail so that it slides into the other side.

To attach the nails, simply use a straight, blunt tool like a jisel, and cut a long, sharp nail through the nail head, like this: Place the nail in the hole, then gently tap it into the nailhead with your nail chisel.

Repeat this process until the nail is big enough to fit through the hole.

If you’re using a chiseled nail, you’re probably going to need to use a very sharp tool to get it through.

If your nail is just a regular nailhead, you should be able to use it to cut the nail out of the hole with a small chisel, then you’ll have the nail sticking out.

Here are a few tips to help you make sure your nailhead fits: If you want to trim the nails on the underside with a saw, you need to make sure the nailheads are flush with the edge on the side that you want them to go in.

The nail heads should be flush with that edge.

If the nail heads aren’t flush, you won’t be able get the nails through the chisels.